4mm Swarovski flatback crystal rhinestones in the colors of aquamarine, light amethyst, and rose are available. Here is the chart we used to determine the hues of the birthstones.)
Steps
1. Attach the birthstone crystal rhinestones on the pendant blank using glue first. (In order to prevent our fingers from getting in the way, we grip our rhinestone stones with tweezers.) On a scrap of paper, apply a small amount of glue. Then take a small amount of glue and dab it onto the back of a rhinestone using a toothpick.
2. Attach the rhinestone on the pendant using the tweezers. To firmly secure the crystal rhinestone, use a fresh, clean toothpick.
3. Follow the same procedure to keep adding the rhinestones, then wait for the adhesive to cure.
4. Next, use two sets of pliers to release a jump ring. To accomplish this, locate the jump ring’s cut, then grab one side of it with a pair of pliers. Using a second set of pliers, secure the jump ring on the opposite side of the cut. Switch one set of pliers’ rotation from up to down. The jump ring will remain circular while being opened in this manner.
5. After that, insert the open jump ring with the love charm.
6. Next, insert the final chain link into the jump ring that is attached to the heart charm. To close the jump ring, press it.
7. Nearly done! To unlock the other jump ring, use two pairs of pliers.
8. Insert the last link of the other end of the chain after sliding the birthstone bar pendant into the exposed jump ring.
9. Snap the jump ring shut.
Slide the birthstone pendant through the heart charm’s opening to wear the birthstone necklace. A lariat it is! Do you think a birthstone necklace is a good idea? Please get in touch with us.
